It is suitable for medium and large theaters, outdoor performances, stadiums, nightclubs, entertainment venues, bars, banquet halls, concert halls and so on.
- The latest class-Damplifier design has low distortion and high efficiency.
- Switched power supply, with high efficiency; soft starter can prevent absorbing large currents into the power grid when starting up and interfering with other electrical devices.
- Effectively suppress power harmonics, and meet the EU green power standard.
- Intelligent peak clipper controls the power module and speaker system to work within a safe range.
- Standard XLR + TRS1/4″ composite input interface, simple interface design is more convenient for different use
- The amplifier has three options of input sensitivity, which can easily accept a wide range of signal source input.
- Suitable for different places, stereo mode or bridge mode is optional.
- Grounded input pin and suspension control switch.
- High-performance 32-bit floating-point DSP chip processor, 96KHz sampling rate, 24-bit A/D and D/A.
- ARM operating system works with a 4-inch touch screen.
- User-friendly PC software supports multiple simultaneous controls.
- Each output channel supports 8-band parameter equalization, electronic frequency division, delay, limiter, gain, polarity and other functions.
- It can be connected to the computer through USB/RS45 interface.
- With over-voltage protection, under-voltage protection, over-temperature protection, over-current protection, DC protection, output short circuit protection, temperature control fan, etc.
- Support DANTE network transmission protocol, low-latency DANTE network audio transmission, 4 sending channels, 4 receiving channels, and network audio extension.
|Output power (20-20KHz/THD≤1%)|
|Stereo/parallel 8Ω × 4: 350W × 4;|
Stereo/parallel 4Ω × 4: 500W × 4;
Bridge 8Ω × 2: 1000W × 2
|Connection||XLR, TRS interface|
|Voltage gain (@ 1KHz)||34.4dB|
|Input impedance||10kΩ unbalanced, 20kΩ balanced|
|Frequency response (under 1W power)||20Hz-20kHz / + 0 / -2dB|
|THD + N (at @ 1/8 power)||≤0.05%|
|Damping coefficient (@ 1KHz)||≥200 @ 8 ohms|
|Resolution (@ 1KHz)||≥80dB|
|Protection method||Over current protection, DC protection, short circuit protection|
|Indicator||Power supply, protection, distortion|
|Cooling method||Fan cooling|
|Powered supply||~ 220V 50Hz|
|Maximum power consumption||2500W|
Building NO. A13-1, Yiku Industrial Park, The Hills, Dongyi Road, Panyu District, Guangzhou, China 511492
NO.19 Chuangyuan Road Zhongcun Town, Panyu District, Guangzhou, China